Thứ Tư, 22 tháng 7, 2015

Nissan Pathfinder 2008-2009 Approved

Nissan Pathfinder 2008-2009 Approved
Format: html
Language: English
Size: 169.3 Mb
The following noise results from variations in field strength, such as fading noise and multi-path noise, or
external noise from trains and other sources. It is not a malfunction.
• Fading noise: This noise occurs because of variations in the field strength in a narrow range due to moun-
tains or buildings blocking the signal.
• Multi-path noise: This noise results from the waves sent directly from the broadcast station arriving at the
antenna at a different time from the waves which reflect off mountains or buildings.
The vehicle itself can be a source of noise if noise prevention parts or electrical equipment is malfunctioning.
Check if noise is caused and/or changed by engine speed, ignition switch turned to each position, and opera-
tion of each piece of electrical equipment, and determine the cause.




 

DOWNLOAD HERE



Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Nissan Pickup 1998-2006 Approved

Nissan Pickup 1998-2006 Approved
Format: html
Language: English
Size: 133.6 Mb
The Supplemental Restraint System ‘‘AIR BAG’’, used along with a seat belt, helps to reduce the risk or
severity of injury to the driver in a frontal collision. The Supplemental Restraint System consists of an air
bag module (located in the center of the steering wheel), a diagnosis sensor unit, warning lamp, wiring har-
ness and spiral cable. Information necessary to service the system safely is included in the RS section of
this Service Manual.




 

DOWNLOAD HERE



Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Nissan Primera 2000.2005 Approved

Nissan Primera 2000.2005 Approved
Format: html
Language: English
Size: 169.1 Mb
  This Procedure is applied only to models with Intelligent Key system and NATS (NISSAN ANTI-THEFT
SYSTEM).
  Remove and install all control units after disconnecting both battery cables with the ignition knob in the
″LOCK″ position.
  Always use CONSULT-II to perform self-diagnosis as a part of each function inspection after finishing
work. If DTC is detected, perform trouble diagnosis according to self-diagnostic results.




 

DOWNLOAD HERE



Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Nissan Quest 2004-2009 Approved

Nissan Quest 2004-2009 Approved
Format: html
Language: English
Size: 358.7 Mb
  To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
  Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
 Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.




 

DOWNLOAD HERE



Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Nissan Rogue 2008-2009 Approved

Nissan Rogue 2008-2009 Approved
Format: html
Language: English
Size: 175.4 Mb
   To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
   Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
   Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.




 

DOWNLOAD HERE



Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Nissan Sentra 2000-2005 Service Repair Manual

Nissan Sentra 2000-2005 Service Repair Manual
Format: html
Language: English
Size: 307.4 Mb
   Be sure to turn the ignition switch “OFF” and disconnect the negative battery terminal before any
repair or inspection work. The open/short circuit of related switches, sensors, solenoid valves, etc.
will cause the MIL to light up.
   Be sure to connect and lock the connectors securely after work. A loose (unlocked) connector will
cause the MIL to light up due to the open circuit. (Be sure the connector is free from water, grease,
dirt, bent terminals, etc.)
   Certain systems and components, especially those related to OBD, may use a new style slide-
locking type harness connector.
For description and how to disconnect, refer to EL section, “Description”, “HARNESS CONNEC-
TOR”.
   Be sure to route and secure the harnesses properly after work. The interference of the harness with
a bracket, etc. may cause the MIL to light up due to the short circuit.
   Be sure to connect rubber tubes properly after work. A misconnected or disconnected rubber tube
may cause the MIL to light up due to the malfunction of the EGR system or fuel injection system,
etc.
   Be sure to erase the unnecessary malfunction information (repairs completed) from the PCM (self-
diagnostic results of engine and the A/T) before returning the vehicle to the customer.




 

DOWNLOAD HERE



Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Nissan Sentra 2006-2009 Service Repair Manual

Nissan Sentra 2006-2009 Service Repair Manual
Format: html
Language: English
Size: 238.7 Mb
G Be sure to turn the ignition switch “OFF” and disconnect the negative battery terminal before any
repair or inspection work. The open/short circuit of related switches, sensors, solenoid valves,
etc. will cause the MIL to light up.
G Be sure to connect and lock the connectors securely after work. A loose (unlocked) connector will
cause the MIL to light up due to an open circuit. (Be sure the connector is free from water, grease,
dirt, bent terminals, etc.)
G Be sure to route and secure the harnesses properly after work. Interference of the harness with a
bracket, etc. may cause the MIL to light up due to a short circuit.
G Be sure to connect rubber tubes properly after work. A misconnected or disconnected rubber tube
may cause the MIL to light up due to a malfunction of the EGR system or fuel injection system, etc.
G Be sure to erase the unnecessary malfunction information (repairs completed) from the TCM and
ECM before returning the vehicle to the customer.




 

DOWNLOAD HERE


Thanks for reading!

Người đăng: vào lúc Không có nhận xét nào:
Nhãn:

Thứ Ba, 21 tháng 7, 2015

Nissan Versa 2007-2009 Service Repair Manual

Nissan Versa 2007-2009 Service Repair Manual
Format: html
Language: English
Size: 182.3 Mb
G This Procedure is applied only to models with Intelligent Key system and NVIS/IVIS (NISSAN/INFINITI
VEHICLE IMMOBILIZER SYSTEM - NATS).
G Remove and install all control units after disconnecting both battery cables with the ignition knob in the
″LOCK″ position.
G Always use CONSULT-II to perform self-diagnosis as a part of each function inspection after finishing
work. If DTC is detected, perform trouble diagnosis according to self-diagnostic results.
For models equipped with the Intelligent Key system and NVIS/IVIS, an electrically controlled steering lock
mechanism is adopted on the key cylinder.
For this reason, if the battery is disconnected or if the battery is discharged, the steering wheel will lock and
steering wheel rotation will become impossible.
If steering wheel rotation is required when battery power is interrupted, follow the procedure below before
starting the repair operation.





 
 
Người đăng: vào lúc Không có nhận xét nào:
Nhãn:
Đăng ký: Bài đăng (Atom)